Ask anyone who looks after a lot of metal equipment where the money goes, and the answer is rarely the original purchase. It’s the repainting and the rust patches that creep in a few years later. At DB Sheetmetals, we apply powder coating to break that cycle before it begins.
Powder coating isn’t paint in the usual sense. A charged powder is applied to the metal and cured under heat until it forms a hard, even shell. Because that shell is tougher than a wet paint film, it resists the knocks and weather that normally start a finish breaking down.
Fewer repairs are where the savings start. Once a coating chips, moisture reaches the bare metal and corrosion follows. A finish that stays intact means fewer touch-ups and fewer pauses while equipment is taken out of use, with a much longer gap before anything needs refinishing.
Cleaning gets easier too. The smooth surface wipes down quickly and stands up to harsh cleaning chemicals, which is why medical and retail equipment so often specifies it. Less time spent scrubbing adds up over years of use.
How long a coating lasts depends heavily on how the metal is prepared. Our line runs a degrease and phosphate stage followed by two rinses, using demineralised water from a reverse osmosis system, so the powder bonds to a properly clean surface. That preparation gives the finish stronger corrosion resistance from day one. Our powder recycling centre also keeps waste down, which helps us keep costs sensible for you.
Want a finish that doesn’t need revisiting every few years? Our powder coating services handle anything from a single cabinet to a full batch of brackets. Call DB Sheetmetals on 01440 706218 or email us at info@dbsheetmetals.co.uk and we’ll talk through the right finish for your equipment.
